Ultra Shield LATE MODEL HALO Full Containment Seat and Cover

Ultra Shield redesigned their Late Model Full Containment Race Seat. The previous version was fully TIG welded to form a 1 piece seat. The new Ultra Shield Late Model Halo Seat arrives at your race shop in 2 pieces, the Head Support is easily bolted onto the remainder of the seat when you are ready to finish the install. The 2 piece version should allow for easier installation into tight cockpit confines and may prevent roof removal in order to get the seat into your race car.

•Made in Texas.

• The Ultra Shield Late Model Halo Seat is constructed from .100 aluminum.

• Shoulder, lap and crotch belt slots are surrounded by aluminum U-channel to prevent sharp edges.

• Compatible with 5 or 6 point selt belts.

• 20 degree lay-back is preferred by most racers.

• Padded seat cover and pre-cut high density foam for the head support are included.

• Bottom is a full 20 inches deep, 5 inches longer than standard seats, for better thigh support in big lap races.

RaceDaySafety.com is a certified Ultra Shield distributor so you will always have factory backing on your race seat.

This item qualifies for RaceDaySafety.com Free Shipping to your home, business or race shop.

To determine the proper size for your race seat you will need to take a measurement of your seated hip width and shoulder height.

To properly measure your "Seated Hip Width":
• Sit on a table or workbench.
• Place 2 rectangular objects (ex. 12 pack boxes or concrete blocks) against each hip. How tightly or loosely you place each box/block will determine the seat fit.
• Use carpenters square against table edge and boxes/blocks to ensure accurate measurement.
• Use metal tape to measure the inside measurement (across hips)of boxes/blocks. (For example, if inside measurement is 16 3/4 inches, we would suggest a 17 inch seat.)

To properly measure your Shoulder Height:
• Sit on a table or workbench.
• Sit in a relaxed driving position (not straight up rigid).
• Use metal tape to take the measurement from seated position to the top of the outside shoulder.

Ultra Shield Late Model Halo Seat measurements: 25 inch Shoulder Belt height. 18 inch Right Rib height. 17 inch Left Rib height. ____________________________________________________________

Ultra Shield Late Model Halo 20 Degree Seats
Ultra Shield LM4020 14 Inch Late Model Halo Seat
Ultra Shield LM4520 14.5 Inch Late Model Halo Seat
Ultra Shield LM5020 15 Inch Late Model Halo Seat
Ultra Shield LM5520 15.5 Inch Late Model Halo Seat
Ultra Shield LM6020 16 Inch Late Model Halo Seat
Ultra Shield LM6520 16.5 Inch Late Model Halo Seat
Ultra Shield LM7020 17 Inch Late Model Halo Seat
Ultra Shield LM7520 17.5 Inch Late Model Halo Seat
Ultra Shield LM8020 18 Inch Late Model Halo Seat