Ultra Shield EFC Full Containment Race Seat
14 Inch 20 Degree
The previous version of the Ultra Shield EFC Seat was fully TIG welded to form a 1 piece seat. The new Ultra Shield EFC Seat arrives at your race shop in 2 pieces, the Head Support is easily bolted onto the remainder of the seat when you are ready to finish the install. The 2 piece version should allow for easier installation into tight cockpit confines and may prevent roof removal in order to get the seat into your race car.
• Ultra Shield EFC Halo 14 inch wide and 20 degree lay-back. Comes with Black Cover.
• Made in Texas.
• The Ultra Shield EFC Seat is constructed from .125 aluminum.
• Lap and crotch belt slots are surrounded by aluminum U-channel to prevent sharp edges.
• Padded seat cover and pre-cut high density foam for the head support are included.
RaceDaySafety.com is a certified Ultra Shield distributor so you will always have factory backing on your race seat.
To determine the proper size for your race seat you will need to take a measurement of your seated hip width and shoulder height.
To properly measure your "Seated Hip Width":
• Sit on a table or workbench.
• Place 2 rectangular objects (ex. 12 pack boxes or concrete blocks) against each hip. How tightly or loosely you place each box/block will determine the seat fit.
• Use carpenters square against table edge and boxes/blocks to ensure accurate measurement.
• Use metal tape to measure the inside measurement (across hips)of boxes/blocks. (For example, if inside measurement is 16 3/4 inches, we would suggest a 17 inch seat.)
To properly measure your Shoulder Height: (standard shoulder height is 25 inches high)
• Sit on a table or workbench.
• Sit in a relaxed driving position (not straight up rigid).
• Use metal tape to measure to take the measurement from seated position to the top of the outside shoulder.
• Ultra Shield EFC Halo 14 inch wide and 20 degree lay-back. Comes with Black Cover.
• Made in Texas.
• The Ultra Shield EFC Seat is constructed from .125 aluminum.
• Lap and crotch belt slots are surrounded by aluminum U-channel to prevent sharp edges.
• Padded seat cover and pre-cut high density foam for the head support are included.
RaceDaySafety.com is a certified Ultra Shield distributor so you will always have factory backing on your race seat.
To determine the proper size for your race seat you will need to take a measurement of your seated hip width and shoulder height.
To properly measure your "Seated Hip Width":
• Sit on a table or workbench.
• Place 2 rectangular objects (ex. 12 pack boxes or concrete blocks) against each hip. How tightly or loosely you place each box/block will determine the seat fit.
• Use carpenters square against table edge and boxes/blocks to ensure accurate measurement.
• Use metal tape to measure the inside measurement (across hips)of boxes/blocks. (For example, if inside measurement is 16 3/4 inches, we would suggest a 17 inch seat.)
To properly measure your Shoulder Height: (standard shoulder height is 25 inches high)
• Sit on a table or workbench.
• Sit in a relaxed driving position (not straight up rigid).
• Use metal tape to measure to take the measurement from seated position to the top of the outside shoulder.
You May Also Like
Recently Viewed